Nitro 4WD V6-4.0L (2007)
16.
Carefully place the ORC module into position and install module fasteners. Tighten ORC module fasteners to 95 in. lbs. (11 N.m) (Figure 1).
17.
Connect the brake lamp switch electrical connector (located on the side of the park brake lever assembly) to the switch.
18.
With the park brake lever in the down position, connect the park brake cable equalizer to the right and left park brake cable.
19.
Pull the park brake handle up and remove the lock out pin.
20.
Verify park brake operation.
21.
Place the park brake lever in the up position and move the console into position.
22.
Place the park brake lever in the down position to allow movement of the console. Line up the console with mounting screw holes and install
console mounting screws.
23.
Place the park brake lever in the up position, connect the 110 volt outlet (if equipped) and install the center console end cap.
24.
Connect the 4x4 shift switch electrical connector (if equipped) and install the shifter bezel.
25.
Zip up the shifter boot and remove the paper clip from the zipper slide.
26.
Connect the negative battery cable.
