Service and Repair for ATE Dual Pin Floating Caliper Disc Brake (Front) | Page 3685
Brake Caliper: Service and Repair
ATE Dual Pin Floating Caliper Disc Brake (Rear)
Fig. 8 Removing dust boot retainer
Fig. 9 Dust boot installation
DUST BOOT, REPLACE
1. Remove dust boot retainer with a suitable screwdriver.
2. Remove dust boot from caliper and piston grooves.
3. Clean piston and caliper grooves, then coat new boot with clean brake fluid.
4. Place boot over piston and into the piston and caliper grooves.
5. Install dust boot retainer into caliper groove.
