RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
Radio/Stereo Noise Filter: Service and Repair
ENGINE TO PLENUM
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig. 8 Engine Ground Strap - 3.7L
2. Remove the attaching bolts from the cylinder heads.
Fig. 10 Ground Strap-to-Heat Shield
3. Remove nut from plenum and remove strap.
INSTALLATION
1. Install the retaining nut and ground strap to the plenum. Tighten to 8 Nm (70 in. lbs.).
2. Install the retaining bolt and ground strap to the engine cylinder heads. Tighten to 12 Nm (106 in. lbs).
3. Connect the battery negative cable.