RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
1. If removed, install the load floor support cylinder (4).
2. Position the load floor (2) into the vehicle and install the two bolts (3) that secure it to the floor panel (1). Tighten the bolts to 40 N.m (30 ft.lbs.).
3. Move the load floor (3) to the down position and install the two nuts (2) that secure the load floor to the floor panel. Tighten the nuts to 25 N.m
(18 ft.lbs.).
4. Move the rear seat cushion (1) to the down position.
A-Pillar Trim
A-Pillar Trim
Removal
1. Open the trim plugs and remove the bolts.
2. Remove the A-Pillar trim/grip handle from the A-Pillar
