RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
REMOVAL
CAUTION: Do not reuse the old power steering pump pulley it is not intended for reuse. A new pulley must be installed if removed.
1. Remove the power steering pump assembly.
Fig. 10
2. Remove the pulley from the pump with an appropriate power steering pulley removal tool.
INSTALLATION
CAUTION: Do not reuse the old power steering pump pulley it is not intended for reuse. A new pulley must be installed if removed.
1. Replace the pulley if it's bent, cracked, or loose.
Fig. 11
2. Install the pulley on the pump with an appropriate power steering pulley installation tool making sure it is flush with the end of the shaft. Ensure
the tool and pulley remain aligned with the pump shaft.
3. Install the power steering pump assembly.
4. Run engine until warm (5 minutes) and note any belt chirp. If chirp exists, move pulley outward approximately 0.5 mm (0.020 inch). If noise
increases, press on 1.0 mm (0.040 inch). Be careful that pulley does not contact mounting bolts.
