RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
Fig. 5
7. Remove dust seal from the housing with a special tool.
CAUTION: Use care not to score the housing bore when prying out seals and washer.
8. Remove retaining ring with snap ring pliers.
9. Remove washer from the housing.
NOTE: Tighten the slide hammer adapter 8990 into the seal using wrenches, in order to make a tight fit to pull the seal out. If this is not
performed the seal may tear on the removal making it difficult to remove.
10. Remove oil seal from the housing with a special tool 8990 with slide hammer C-3752.
INSTALLATION
NOTE: Generous amounts of the high temperature grease from the seal kit should be applied to areas between the pitman shaft bearing and oil seals
and also between the dust seals and snap ring.
1. Coat the oil seal and washer with high temp grease.
NOTE: Install the oil seal with the lip facing inward. Flat side of the oil seal should be against the washer.
Fig. 7
