RAM 1500 Truck 2WD V6-3.7L VIN K (2003)
18. Remove rear pinion bearing (Fig. 56) from the pinion shaft with Puller C-293-PA and Adapters C-293-37.
19. Remove pinion depth shim (Fig. 57) from the pinion shaft and record shim thickness.
INSTALLATION
NOTE: The ring gear and pinion are serviced in a matched set. Do not replace one gear without replacing the other matching gear. If ring and pinion
gears or bearings are replaced, Refer to Adjustments for Pinion Gear Depth Setting.
1. Apply Mopar Door Ease or equivalent stick lubricant to outside surface of the pinion bearing cups.