RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
11.
Remove the mirror flag seal from the inner door panel (Figure 5).
12.
Unplug the wire harness connector from the outside power mirror (Figure 6).
13.
Remove the three nuts that secure the outside power mirror to the inner door panel.
14.
Unseat the outside power mirror wire harness grommet by pushing the grommet out through the hole in the door flag from the inside.
15.
Pull the mirror from the outside of the door while feeding the wire harness and connector out through the hole from inside the door.
16.
From the outside of the door, feed the wire harness and connector of the new outside power mirror (see Parts Required section) through the hole to
the inside of the door then, seat the grommet.
17.
Attach the outside power mirror to the door using the three nuts. Tighten the nuts to 7.5 N.m (65 in.lbs.).
18.
Engage the outside power mirror wire harness connector.
19.
Attach the mirror flag seal onto the inner door.
20.
If performing this repair procedure to the driver side power mirror, engage the outside power mirror switch connector.
21.
If equipped, engage the power window/power lock switch connector.
22.
Position the trim panel onto the door.
23.
Engage all door trim panel attaching clips around the perimeter of the trim panel, attaching trim panel to the inner door.
24.
Install the screws securing the pull cup to the inner door panel.
25.
Install the screw attaching the trim panel to the outside mirror frame.
26.
Install the window crank, if equipped.
