RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
Controller Mounting Screws
4. Remove screws attaching CAB to the HCU.
5. Remove the CAB.
INSTALLATION
1. Place the CAB onto the HCU.
NOTE: Insure the CAB seal is in position before installation.
2. Install the mounting screws and tighten to 4 - 4.7 Nm (36 - 42 inch lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Connect battery.
Rear Wheel Antilock Brake System
NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the new CAB. For axle type refer
to Transmission and Drivetrain. For tire revolutions per mile refer to Steering and Suspension.
REMOVAL
CAB Harness Connections
1. Pull up on the CAB harness connector lock release and remove the connector from the controller.
2. Remove the RWAL valve harness connector from the controller.
