RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
NOTE: Position wheel speed sensor wire at the top of the knuckle if equipped.
7. Align bolt holes in hub/bearing flange with bolts installed in knuckle. Then thread bolts into bearing flange far enough to hold assembly in place.
8. Install remaining bolts. Tighten hub/bearing bolts to 170 Nm (125 ft. lbs.).
9. Install washer and hub nut and tighten to 237 Nm (175 ft. lbs.).
10. Install new cotter pin in hub nut. Tighten nut as needed to align cotter pin hole in shaft with opening in nut.
11. Install brake caliper.
12. Install sensor wire to the steering knuckle and frame if equipped. Connect the wheel speed sensor wire under the hood.
13. Install wheel and tire assemblies.
14. Remove support and lower the vehicle.
15. Apply brakes several times to seat brake shoes and caliper piston. Do not move vehicle until firm brake pedal is obtained.
