RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
Parking Brake Pedal: Service and Repair
REMOVAL
1. Release parking brakes.
2. Raise vehicle.
3. Loosen cable tensioner nut at equalizer to create slack in front cable.
4. Lower vehicle.
5. Remove knee bolster.
6. Disconnect brake lamp wire from switch on pedal assembly.
7. Roll carpet back, loosen front cable grommet from floorpan and cable retainer.
8. Disengage cable end connector from arm on pedal assembly.
Located In The LH Footwell
9. Remove bolts/nuts from pedal assembly and remove assembly.
INSTALLATION
1. Position replacement pedal assembly on dash and cowl.
2. Install bolts/nuts and tighten to 28 Nm (21 ft. lbs.).
3. Connect front cable to arm on pedal assembly.
4. Tighten front cable grommet to floorpan and cable retainer, roll carpet back.
5. Connect wires to brake lamp switch.
6. Install knee bolster.
7. Raise vehicle.
8. Adjust parking brake cable tensioner.
