RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
Cruise Control Switch: Service and Repair
Speed Control Switches
WARNING: BEFORE BEGINNING ANY AIR BAG SYSTEM COMPONENT REMOVAL OR INSTALLATION, REMOVE AND
ISOLATE THE NEGATIVE (-) CABLE(S) FROM THE BATTERY. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG
SYSTEM. THEN WAIT TWO MINUTES FOR SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER SYSTEM SERVICE.
FAILURE TO DO THIS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE INJURY.
REMOVAL
1. Disconnect and isolate negative battery cable(s).
2. Remove airbag module. Refer to Passive Restraint Systems for procedures.
3. Remove switch-to-steering wheel mounting screws.
4. Remove switch.
5. Remove electrical connector at switch.
INSTALLATION
1. Install electrical connector to switch.
2. Install switch and mounting screws.
3. Tighten screws to 3 N.m (26 in lbs +/- 2 in lbs) torque.
4. Install airbag module. Refer to Passive Restraint Systems for procedures.
5. Connect negative battery cable(s).