RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
Passenger Side Airbag On/Off Switch Remove/Install
7. Remove the three screws that secure the passenger side airbag on/off switch to the back of the switch bezel.
8. Remove the passenger side airbag on/off switch from the switch bezel.
INSTALLATION
1. Position the passenger side airbag on/off switch to the back of the switch bezel.
2. Install and tighten the three screws that secure the passenger side airbag on/off switch to the switch bezel. Tighten the screws to 2.2 Nm (20 in lbs)
.
3. Route the passenger side airbag on/off switch wire harness through the switch bezel opening of the instrument panel.
4. Reach through the glove box opening to access and reconnect the two passenger side airbag on/off switch wire harness connectors to the
instrument panel wire harness. These connectors are retained on a bracket located on the inboard glove box opening reinforcement. Be certain that
both connectors are fully engaged and latched.
5. Position the passenger side airbag on/off switch bezel to the opening in the instrument panel.
6. Install and tighten the three screws that secure the passenger side airbag on/off switch bezel to the instrument panel. Tighten the screws to 2.2 Nm
(20 in lbs).
7. Install the glove box onto the instrument panel. Refer to Glove Box in the Replacement of Instrument Panel Systems for the procedures.
8. Install the cluster bezel onto the instrument panel. Refer to Cluster Bezel in the Replacement of Instrument Panel Systems for the procedures.
9. Do not reconnect the battery negative cable at this time. Refer to Airbag System in the Diagnosis and Testing for the proper procedures.
