RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
Steering Column Cover: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
Steering Column Opening Cover Remove/Install
2. Remove the three screws that secure the lower edge of the steering column opening cover to the lower instrument panel reinforcement.
3. Using a trim stick or another suitable wide flat-bladed tool, gently pry the upper edge of the steering column opening cover just below the cluster
bezel on each side of the steering column away from the instrument panel far enough to disengage the snap clip retainers from the receptacles in
the instrument panel.
4. Remove the steering column opening cover from the instrument panel.
INSTALLATION
1. Position the steering column opening cover to the instrument panel.
2. Align the snap clip retainers on the steering column opening cover with the receptacles in the instrument panel.
3. Press firmly on the steering column opening cover over the snap clip locations until each of the snap clips is fully engaged in its receptacle.
4. Install and tighten the three screws that secure the lower edge of the steering column opening cover to the lower instrument panel reinforcement.
Tighten the screws to 2.2 N.m (20 in lbs).
5. Reconnect the battery negative cable.
