RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
6. Coat the dust seal with special grease supplied with the new seal.
7. Install dust seal with a driver and handle.
8. Install pitman shaft to side cover by screwing shaft in until it fully seats to side cover.
9. Install preload adjuster nut. Do not tighten nut until after Over-Center Rotation Torque adjustment has been made.
10. Install gasket to side cover and bend tabs around edges of side cover.
11. Install pitman shaft assembly and side cover to housing.
12. Install side cover bolts and tighten to 60 Nm (44 ft. lbs.).
13. Perform over-center rotation torque adjustment.
Spool Valve
DISASSEMBLY
1. Remove lock nut.
2. Remove adjuster nut with Spanner Wrench C-4381.
3. Remove thrust support assembly out of the housing.
