RAM 1500 Truck 2WD V6-3.9L VIN X (1999)
Fig. 70
3. Align and position upper housing separator plate on transfer plate (Fig. 70).
4. Install brace plate. Tighten brace attaching screws to 4 Nm (35 inch lbs.) torque.
5. Install remaining separator plate attaching screw. Tighten Brews to 4 Nm (35 inch lbs.) torque
Upper And Lower Housing
Fig. 71
1. Position upper housing so internal passages and check ball seats are facing upward. Then install check balls in housing (Fig. 71). Seven check
balls are used. The single large check ball is approximately 8.7 mm (11/32 inch) diameter. The single small check ball is approximately 4.8 mm
(3/16 inch) in diameter. The remaining 6 check balls are approximately 6.3 mm (1/4 inch) in diameter.
