RAM 1500 Truck 2WD V8-4.7L (2008)
6. Install the defrost door actuator (1) onto the back of the HVAC housing (2). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the defrost door actuator coupler (4).
7. Install the screws (1) that secure the defrost door actuator (2) to the HVAC housing (3). Tighten the screws to 1.1 Nm (10 in. lbs.).
8. Connect the HVAC wire harness connector (4) to the defrost door actuator.
9. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation .
10. Reconnect the negative battery cable.
Recirculation Door Actuator - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
