RAM 1500 Truck 2WD V8-4.7L (2008)
Control Assembly: Service and Repair
A/C Heater Control - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in an accidental airbag deployment and possible personal injury or death.
NOTE: Single zone A/C-heater control shown. Dual zone similar.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel (1) from the instrument panel and disconnect the wire harness connectors (4 and 5) from the back of the A/C-heater
control (2) See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Center Bezel -
Removal .
NOTE: Take the proper precautions to protect the front face of the center bezel from cosmetic damage.
3. Place the center bezel on a workbench and remove the four screws (3) that secure the A/C-heater control to the center bezel and remove the
control.