RAM 1500 Truck 2WD V8-4.7L (2008)
NOTE: This lamp is used on vehicles with a pick-up bed and dual rear wheels only. A lamp with a red lens and containing three bulbs is located
on the rearward facing surface of the pick-up bed sill below the tailgate. The bulb types and service procedures are identical for all three of
these bulbs.
1. Align the base of the bulb (2) with the socket (3).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the bottom of the tailgate marker lamp lens/housing (1).
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Position the marker lamp to the outer surface of the sill panel.
7. Install and tighten the two screws that secure the marker lamp lens/housing to the tailgate panel. Tighten the screws to 2 Nm (20 in. lbs.).
8. Reconnect the battery negative cable.
