RAM 1500 Truck 2WD V8-4.7L (2008)
7. Disconnect the wheel speed sensor wire (3) from the knuckle and upper control arm.
8. Remove the stabilizer link lower nut (1).
9. Remove the axle hub nut.
10. Remove the shock lower bolt/nut from the lower control arm (5) then move the shock out of the way to allow the C4212-F press (4) to used.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
11. Install special tools to press the bushing (3) out of the lower control arm (4) using special tools C-4212-F (Press) (1), 9653-1 (driver) (5) and
9653-2 (Receiver) (2).
