RAM 1500 Truck 2WD V8-4.7L VIN N (2002)
Engine Coolant Temperature (ECT) Sensor: Service and Repair
ENGINE COOLANT TEMPERATURE SENSOR
REMOVAL
3.7L
The Engine Coolant Temperature (ECT) sensor is installed into a water jacket at front of intake manifold near rear of generator.
WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE INJURY BY SCALDING. COOLING SYSTEM MUST BE PARTIALLY
DRAINED BEFORE REMOVING THE COOLANT TEMPERATURE SENSOR.
1. Partially drain the cooling system.
2. Disconnect the electrical connector from the sensor.
3. Remove the sensor from the intake manifold.
4.7L
WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE INJURY BY SCALDING. COOLING SYSTEM MUST BE PARTIALLY
DRAINED BEFORE REMOVING THE ENGINE COOLANT TEMPERATURE (ECT) SENSOR.
