dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - Engine Idle Fluctuation|Page 3438 > < Engine Controls - Flash Programming Failure Recovery|Page 3433
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - Engine Idle Fluctuation

NUMBER: 18-036-03

GROUP: Vehicle Performance

DATE: October 10, 2003

THIS BULLETIN IS BEING PROVIDED IN ADVANCE. THE SOFTWARE WILL BE AVAILABLE ON TechCONNECT ON OR AFTER OCT.
27, 2003.

SUBJECT:
Flash: Engine Idle Fluctuation

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software.

MODELS:

2002

(DR)

Ram Truck

NOTE

This bulletin applies to vehicles equipped with a 4.7L engine (Sales Code EVA) and a 5 speed manual transmission (Sales Code DDC).

SYMPTOM/CONDITION:

The customer may experience the engine idle fluctuating.

DIAGNOSIS:

Using a Scan Tool (DRBIII(R)) with the appropriate Diagnostic Procedures Manual, verify all engine systems are functioning as designed. If DTCs are
present record them on the repair order and repair as necessary before proceeding further with this bulletin.

If the customer describes the Symptom/Condition, perform the Repair Procedure.

PARTS REQUIRED:

SPECIAL TOOLS/EQUIPMENT REQUIRED:

NOTE:

An updated J1962 cable has been released. This cable has a red colored connector at the DRBIII(R) connection. Use this cable whenever a flash is
being performed.

REPAIR PROCEDURE:

NOTE:

Whenever a controller is programmed, the software in the DRBIII(R); must be programmed with the latest revision level available.

NOTE:

Engine Controls - Engine Idle Fluctuation|Page 3438 > < Engine Controls - Flash Programming Failure Recovery|Page 3433