RAM 1500 Truck 2WD V8-4.7L VIN N (2002)
Transmission Control Module: Service and Repair
TCM QUICK LEARN
The quick learn procedure requires the use of the DRB scan tool.
This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn
procedure should be performed if any of the following procedures are performed:
-
Transmission Assembly Replacement
-
Transmission Control Module Replacement
-
Solenoid Pack Replacement
-
Clutch Plate and/or Seal Replacement
-
Valve Body Replacement or Recondition
To perform the Quick Learn Procedure, the following conditions must be met:
-
The brakes must be applied
-
The engine speed must be above 500 rpm.
-
The throttle angle (TPS) must be less than 3 degrees.
-
The shift lever position must stay in PARK until prompted to shift to overdrive
-
The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRB indicates the procedure is complete
-
The calculated oil temperature must be above 60 ° and below 200 °
ELECTRONIC PINION FACTOR WARNINGS (IF APPLICABLE)
The pinion factor must be set when replacing the TCM. Note: The pinion factor is a fixed number and cannot be changed or updated in some vehicle
applications. If the pinion factor is not set or incorrectly set, any speed related functions will not operate correctly i.e. speedometer, speed control,
rolling door locks, other control modules will be affected that depend on speed information.
