RAM 1500 Truck 2WD V8-4.7L VIN N (2002)
Seals and Gaskets: Service and Repair
Removal and Installation - Front Axle
Front Axle - C250F
Axle Shaft Seals
REMOVAL
1. Place transmission in neutral.
2. Raise and support vehicle.
3. Remove half shaft from vehicle.
4. Remove skid plate, if equipped.
5. Clean axle seal area.
6. Remove axle shaft O-ring.
7. Remove axle shaft.
8. Remove axle shaft seal with a small pry bar.
INSTALLATION
1. Clean axle shaft bore clean.
2. Install a new axle shaft seal with Installer X694 and Handle C-4171.
3. Lubricate seal lip with gear lubricant.
4. Insert axle shaft through seal, bearing, and engage it into side gear splines. Push firmly on the axle shaft to engage the snap-ring.
NOTE: Use care to prevent shaft splines from damaging axle shaft seal lip.
5. Install axle shaft O-ring.
6. Check the differential fluid level and add fluid if necessary.
7. Install skid plate, if necessary.
8. Install half shaft.
9. Remove support and lower vehicle.
