RAM 1500 Truck 2WD V8-5.2L VIN Y (1997)
Cruise Control Switch: Service and Repair
WARNING: BEFORE ATTEMPTING TO DIAGNOSE, REMOVE OR INSTALL ANY AIRBAG SYSTEM OR RELATED STEERING
WHEEL AND STEERING COLUMN COMPONENTS YOU MUST FIRST DISCONNECT AND ISOLATE THE BATTERY NEGATIVE
(GROUND) CABLE. WAIT 2 MINUTES FOR SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER SYSTEM SERVICE.
FAILURE TO DO SO COULD RESULT IN ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate negative battery cable from battery.
Speed Control Switch Remove/Install
2. From underside of steering wheel, remove 2 speed control switch mounting screws.
3. Pull switch module assembly from wheel and unplug electrical connector.
INSTALLATION
1. Plug electrical connector into switch module.
2. Install switch with 2 screws.
3. Tighten screws to 1.5 N.m (15 in. lbs.) torque.
