RAM 1500 Truck 2WD V8-5.2L VIN Y (1997)
Condition
-
The wiper motor will stop when the wiper/ washer switch is set in the Off position, but the wipers do not continue running to the park position.
Procedure
1. Unplug the motor wire harness connector and clean the terminals. Plug in the wire harness connector and test the motor. If not OK, go to Step 2.
2. Set the wiper/washer switch in the Off position. Unplug the motor wire harness connector. Connect a voltmeter or test lamp to the motor ground
strap. Connect the other lead to terminal Pi of the wire harness connector. If voltage is not present, check for an open circuit in the wire harness or
the multi-function switch. If voltage is present, go to Step 3.
Ohmmeter Between Terminal L And P2
3. Connect an ohmmeter or continuity tester between motor terminals L and P2. If there is continuity between these terminals, replace the faulty
wiper module assembly If there is no continuity, the problem is an open in the wire harness or a faulty multi-function switch.
