RAM 1500 Truck 2WD V8-5.7L (2011)
33. Snap the door panel to the door shell.
34. Install the door panel upper and lower retaining screws.
35. Install the two door panel retaining screws located inside the door panel grab handle.
36. Install the door panel grab handle bezel (Figure 17).
37. Install the inside door handle bezel.
38. Clean the glass using Mopar Glass Cleaner (P/N 04318014AB) or equivalent.
F. Rear Swing Gate Latch Replacement (JK Models)
1. Open the swing gate.
2. Remove the access panel/grate (Figure 22).
3. Disconnect the swing gate latch electrical connector (Figure 23).
4. Disconnect the door link rods at the swing gate latch (Figure 23).