RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
panel directly off of the door or damage to the trim panel and/or the power switch assembly will occur.
2.
Remove the front door radio speaker from its mounting to the door. Do not disconnect the electrical connection to the speaker.
3.
Turn the ignition switch to the "ON" position. DO NOT start the vehicle engine.
4.
Hold the radio speaker by its magnet in your hand.
5.
Operate the radio as described above in the Diagnosis section
6.
Listen from the side of the speaker for the buzz-like sound.
7.
Is the buzz-like sound coming from the speaker?
a.
If YES >>> then turn the ignition switch to the "OFF" position and replace the radio speaker. Proceed to the next step.
b.
If NO >>> then turn the ignition switch to the "OFF" position and install the radio speaker to the inner door panel. Proceed to the next step.
8.
Loose fit the new sound insulation to the back side of the front door trim panel. DO NOT remove the original sound insulation from the door trim
panel. The new sound insulation will install over the original door sound insulation and extends to the bottom of the door. Note the pieces of
adhesive tape on the new sound insulation.
9.
Remove the backing from a piece of adhesive tape and adhere the tape to the original sound insulation and/or back side of the trim panel.
10.
Finish attaching the remain pieces of adhesive tape to the original sound insulation and/or back side of the trim panel.
11.
Verify that the new sound insulation is installed correctly.
12.
Install the interior door trim panel to the door.
13.
Verify that the buzz-like sound is corrected.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
Technical Service Bulletin # 23-018-06
Date:
060505
Audio System - Door Area Buzzing Sound With Audio ON
