RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Hydraulic System Junction Block: Service and Repair
BRAKE JUNCTION BLOCK
REMOVAL
1. Remove the brake lines (1) from the junction block (2).
2. Remove the junction block (2) mounting bolt and remove the junction block from the bracket.
INSTALLATION
1. Position the junction block (2) on the bracket and install the mounting bolt. Tighten the mounting bolt to 23 Nm (210 inch lbs.).
2. Install the brake lines (1) into the junction block (2) and tighten to 19 - 23 Nm (170 - 200 inch lbs.).
3. Bleed the base brake system.
