RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
11. Remove the oil pan mounting bolts using the sequence above, and remove oil pan.
NOTE: The double ended oil pan studs must be installed in the same location that they were removed from.
12. Unbolt oil pump pickup tube and remove tube.
NOTE: When the oil pan is removed, a new oil pan gasket/windage tray assembly must be installed. The old gasket cannot be reused.
13. Discard the integral windage tray and gasket and replace.
INSTALLATION
1. Clean the oil pan gasket mating surface of the block and oil pan.
NOTE: Mopar Engine RTV must be applied to the 4 T-joints, (area where front cover, rear retainer, block, and oil pan gasket meet). The bead of
RTV should cover the bottom of the gasket. This area is approximately 4.5 mm x 25 mm in each of the 4 T-joint locations.
2. Apply Mopar Engine RTV at the 4 T-joints.
NOTE: When the oil pan is removed, a new integral windage tray and gasket assembly must be installed. The old gasket cannot be reused.
