RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Exhaust Pipe: Service and Repair
Exhaust Pipe
PIPE EXHAUST
REMOVAL
3.7L/4.7L/5.7L ENGINE
1. Raise and support the vehicle.
2. Saturate the bolts and nuts with heat valve lubricant. Allow 5 minutes for penetration.
3. Remove exhaust pipe to manifold bolts, retainers and nuts.
4. Remove the clamp nuts.
5. Remove the exhaust pipe.
INSTALLATION
1. Position the exhaust pipe for proper clearance with the frame and underbody parts. A minimum clearance of 25.4 mm (1.0 inch) is required.
2. Position the exhaust pipe to manifold. Install the bolts, retainers and nuts. Tighten the nuts to 31 Nm (23 ft. lbs.) torque.
3. Tighten the clamp nuts to 54.2 Nm (40 ft. lbs.) torque.
4. Lower the vehicle.
5. Start the engine and inspect for exhaust leaks and exhaust system contact with the body panels. Adjust the alignment, if needed.
