RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Brake Light Bulb: Service and Repair
Bulb - Pick-Up
NOTE: The rear lamp unit contains three bulbs: park/turn signal, park/brake/side marker, and backup. The service procedures for each bulb are the
same, only the bulb sizes and types may differ.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit (1) from the end of the quarter panel.
3. Remove the four screws (3) that secure the socket plate (2) to the back of the rear lamp unit housing.
4. Remove the socket plate from the rear lamp unit.
5. Pull the base of the backup (1), park/brake/side marker (2) or park/turn signal (3) lamp bulb straight out of the appropriate socket in the socket
plate (5).
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the
socket and/or the lamp wiring.
1. Align the base of the backup (1), park/brake/side marker (2) or park/turn signal (3) lamp bulb with the appropriate socket in the socket plate (5).
