RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Engine Control Module: Service and Repair
Module - Powertrain Control
CAUTION:
-
Certain ABS systems rely on having the Powertrain Control Module (PCM) broadcast the Vehicle Identification Number (VIN) over the bus
network. To prevent problems of DTCs and other items related to the VIN broadcast, it is recommend that you disconnect the ABS CAB
(controller) temporarily when replacing the PCM. Once the PCM is replaced, write the VIN to the PCM using a scan tool. This is done from the
engine main menu. Arrow over to the second page to "1. Miscellaneous". Select "Check VIN" from the choices. Make sure it has the correct VIN
entered before continuing. When the VIN is complete, turn off the ignition key and reconnect the ABS module connector. This will prevent the
setting of DTCs and other items associated with the lack of a VIN detected when you turn the key ON after replacing the PCM.
-
Use the scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original mileage. If this step
is not done, a Diagnostic Trouble Code (DTC) may be set.
REMOVAL
The PCM (1) is located in the engine compartment attached to the dash panel (3).
To avoid possible voltage spike damage to the PCM, ignition key must be off, and negative battery cable must be disconnected before unplugging PCM
connectors.
1. Disconnect negative battery cable at battery.
