RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
7. Install and tighten the screw that secures the turning loop to the height adjuster. Tighten the screw to 39 N.m (29 ft. lbs.).
8. Engage the upper edge of a new trim cover over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
REAR - MEGA CAB
REMOVAL
1. Unsnap the trim cover (4) from the front seat belt turning loop (3) and discard.
2. Remove the screw (5) that secures the seat belt turning loop to the height adjuster (1) on the upper C-pillar.
3. Remove the seat belt turning loop from the height adjuster.
4. Remove the upper trim (2) from the inside of the C-pillar.
5. Loosen the two screws that secure the height adjuster far enough to remove the adjuster from the upper C-pillar.
6. Disengage the tab of the height adjuster from the slot in the sheet metal and remove the adjuster from the inside of the C-pillar.
INSTALLATION
1. Position the rear seat belt turning loop height adjuster (1) to the inside of the upper C-pillar.
2. Engage the tab on the height adjuster into the slot in the sheet metal of the inner C-pillar.
3. Hand tighten the lower of the two screws that secure the height adjuster to the C-pillar far enough to keep the tab on the adjuster engaged in the
C-pillar slot.
4. Install the upper screw that secures the seat belt turning loop height adjuster to the upper C-pillar, then tighten both the upper and lower screws to
39 N.m (29 ft. lbs.).
5. Reinstall the upper trim (2) onto the inside of the C-pillar.
6. Position the seat belt turning loop (3) onto the height adjuster on the upper C-pillar.
7. Install and tighten the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 N.m (29 ft. lbs.).
8. Engage the upper edge of a new trim cover (4) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
