RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
1. Position the side impact sensor (4) to the large hole above the retractor mounting hole in the inner B-pillar (2).
2. Reconnect the body wire harness connector (1) to the sensor connector receptacle.
3. Reach through the large hole above the retractor mounting hole in the inner B-pillar to position and engage the anti-rotation pin and the stud on the
side impact sensor to the locating slot and mounting hole from the inside of the B-pillar.
4. Install and tighten the nut (3) that secures the side impact sensor stud to the inner B-pillar. Tighten the nut to 8 N.m (70 in. lbs.).
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.