RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Power Distribution Module: Service and Repair
Front Control Module
REMOVAL
1. Disconnect and isolate the battery negative cable (3).
2. Partially remove the Integrated Power Module (IPM) (4) from the engine compartment.
3. Remove the Front Control Module (FCM) retaining screws.
4. Using both hands, separate the FCM from the IPM assembly disengaging the 49-way electrical connector and remove the FCM from the vehicle.
INSTALLATION
1. Install the Front Control Module (FCM) onto the Integrated Power Module (IPM) (4) by pushing the 49-way electrical connector straight in.
2. Install the FCM retaining screws. Torque the screws to 7 in. lbs.
3. Install the IPM.
4. Connect the battery negative cable.
5. Verify normal vehicle operation.
