RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
A.
Front Tire Cross-Switch and Front End Alignment:
1.
Cross-switch the front tire and wheel assemblies (left front to right front, and right front to left front).
2.
With the front tire and wheel assemblies removed, inspect the front brakes for problems (i.e. grease, dragging brake pads, etc.) that may cause a
drift condition.
3.
Verify that the front suspension components are in good condition.
4.
Align the vehicle front end to the following specifications:
NOTE:
Follow the above alignment specification. Pay particular attention to large differences in: left to right caster and left to right toe readings.
5.
Road test the vehicle to verify that the condition has been corrected.
B.
Front Lower Control Arm Bushings Replacement:
1.
Replace the left and right side front lower control arm bushings. Refer to TechCONNECT for detailed repair procedures: select the SERVICE
INFO tab > 2 - SUSPENSION > FRONT > BUSHINGS > REMOVAL and INSTALLATION.
NOTE:
For the front lower control arm, the front (leading) bushing is different from the rear (trailing) bushing. Take care to install the correct bushing.
2.
Verify that the front suspension components are in good condition.
