RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Steering Gear: Service and Repair
Gear Removal and Installation
GEAR-INDEPENDENT FRONT SUSPENSION
REMOVAL
NOTE: The steering column on vehicles with an automatic transmission may not be equipped with an internal locking shaft that allows the ignition
key cylinder to be locked with the key. Alternative methods of locking the steering wheel for service will have to be used.
1. Lock the steering wheel.
2. Drain and siphon the power steering fluid from the reservoir.
3. Raise the vehicle.
4. Remove and discard the steering coupler pinch bolt.
5. Remove the power steering hoses from the rack & pinion.
6. Remove the tire and wheel assembly
7. Remove the tie rod end nuts and separate tie rod ends from the knuckles with puller 8677.
8. Remove the skid plate.
9. Remove the rack & pinion mounting bolts (1).
10. Remove the rack & pinion (2) from the vehicle.
INSTALLATION
NOTE: Before installing gear inspect bushings and replace if worn or damaged.
NOTE: In the frame there are two holes for the mounting of the steering gear, one is slotted and one is round. When tightening the gear to
specifications make sure to tighten the mounting bolt with the hole first to avoid movement of the steering gear.