RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Wheel Bearing: Service and Repair
Installation
HUB / BEARING
INSTALLATION
4X2
1. Install the brake dust shield (2). SRT10 Excluded in this step.
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts (5) to 163 Nm (120 ft. lbs.) 4X2 LD. Or tighten the bolts (5) to 176
Nm (130 ft. lbs.) 4X2 HD..
3. Install the brake rotor and caliper.
4. Install the ABS wheel speed sensor if equipped (4).
5. Install the wheel and tire assembly.
6. Remove the support and lower vehicle.