RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
3. Install the bolts (1) to hold the transmission solenoid/TRS assembly onto the valve body.
4. Tighten the solenoid assembly screws adjacent to the arrows cast into the bottom of the valve body first. Tighten the screws to 6 Nm (50 inch lbs.)
.
5. Tighten the remainder of the solenoid assembly screws to 6 Nm (50 inch lbs.).
6. Install the valve body into the transmission.
Sensor-Line Pressure
SENSOR-LINE PRESSURE
REMOVAL
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
3. Remove the wiring connector from the line pres sure sensor (2).
4. Remove the bolt holding the line pressure sensor (2) to the transmission case.
5. Remove the line pressure sensor (2) from the transmission case.
INSTALLATION
