RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
1. Install Solenoid/Pressure Switch Assembly (1) and screen (3) to the separator and transfer plates.
2. Install and tighten retaining screws (2) to 5.5 Nm (50 inch lbs.) torque.
3. Install valve body.
Solenoid Pressure Control
SOLENOID PRESSURE CONTROL
REMOVAL
1. Remove the valve body from the transmission.
2. Remove the electrical connectors from the pressure control solenoid (1) and the line pressure sensor (2).
3. Remove the screws (6) holding the pressure control solenoid (1) and line pressure sensor (2) to the valve body.
4. Remove the pressure control solenoid and line pressure sensor from the valve body