RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Overdrive Switch: Service and Repair
45RFE/545RFE Automatic Transmission
SWITCH-TOW/HAUL OVERDRIVE
REMOVAL
1. Using a plastic trim tool, remove the tow/haul over drive off switch retainer (2) from the shift lever (1).
2. Pull the switch (2) outwards to release it from the connector in the lever (1)
INSTALLATION
NOTE: There is enough slack in the wire to pull out the connector from the lever.
1. Pull the connector (2) out of the lever (1) just enough to grasp it.
CAUTION: Be careful not to bend the pins on the tow/haul overdrive off switch. Use care when installing the switch, as it is not indexed, and can
be accidentally installed incorrectly.
2. Install the tow/haul overdrive off switch (3) into the connector (2)
3. Push the tow/haul overdrive off switch (3) and wiring into the shift lever (1).
