RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Hydraulic Hose: Service and Repair
LINKAGE
REMOVAL
CAUTION: The hydraulic linkage has a quick disconnect at the slave cylinder. This fitting should never be disconnected or tampered with. Once the
hydraulic line is connected to the slave cylinder, it should never be disconnected.
1. Raise and support vehicle.
2. Remove heat shield over hydraulic line.
3. Remove slave cylinder (2) nuts (1) on clutch housing.
4. Remove slave cylinder from clutch housing.
5. Remove plastic clip securing the hydraulic line to the dash panel from the lower dash panel flange.
6. Remove plastic clip securing hydraulic line to the dash panel from the upper dash panel stud.
7. Lower vehicle.
8. Disconnect clutch pedal interlock switch connector (2).
9. Remove clutch master cylinder (1) rod pin (3).
10. Verify that cap on clutch master cylinder reservoir is tight. This will avoid spillage during removal.
11. Remove clutch master cylinder nuts holding cylinder to the dash panel.
12. Remove clutch cylinders, reservoir and connecting lines from vehicle.
INSTALLATION
1. Position cylinders and connecting line in vehicle engine compartment. Position clutch hydraulic line against the dash panel and behind all engine
hoses and wiring.
2. Apply a light coating of grease to the inside diameter of the master cylinder push rod eye.
