RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
4. Install alignment tool (3) in pilot bearing and position disc on the flywheel (1).
5. Position pressure plate over disc (2) and onto the flywheel.
6. Align and hold pressure plate in position and install bolts finger tight.
7. Tighten bolts evenly and a few threads at a time in a diagonal pattern.
CAUTION: Bolts must be tightened evenly and to specified torque to avoid warping pressure plate cover.
8. Tighten pressure plate bolts to:
^
V6 & V8 Engines - 50 Nm (37 ft. lbs.)
^
V10 & Diesel Engines - 30 Nm (22 ft. lbs.)
9. Remove release lever (3) and release bearing from clutch housing (1). Apply Mopar high temperature bearing grease to bore (4) of release bearing,
release lever (5) contact surfaces and release lever pivot stud (2).
