RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
9. Grasp protruding bearing cap with vise jaws and tap link yoke with a mallet to remove bearing cap.
10. Flip assembly and repeat Step 6, Step 7, Step 8 and Step 9 to remove the opposite bearing cap.
11. Remove cross centering kit assembly and spring.
12. Press remaining bearing caps out the other end of the link yoke.
ASSEMBLY
CAUTION: All alignment marks on the link yoke and propeller shaft yoke must be aligned during assembled.
1. Apply (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores.
2. Fit cross into the propeller shaft yoke.
