RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
Seals and Gaskets: Service and Repair
SEAL-EXTENSION HOUSING
REMOVAL
NOTE: If extension housing slip yoke bushing is worn the housing must be replaced,
1. Remove propeller shaft.
2. Remove seal with a seal pick (1).
3. Clean and inspect extension housing where the seal was located.
INSTALLATION
1. Install seal into extension housing (3) with Installer 9372 (1) and Handle C4171(2).
2. Install propeller shaft.
3. Check transmission fluid level.