RAM 1500 Truck 2WD V8-5.7L VIN 2 (2006)
1. Position the wiper module (6) into the cowl plenum (8) as a unit.
2. Install the two screws (9) that secure the wiper module to the top of the cowl plenum panel at the pivot brackets. Tighten the screw on the driver
side, followed by the screw on the passenger side. Tighten the screws to 8 N.m (75 in. lbs.)
3. Install and tighten the screw that secures the wiper module to the bottom of the cowl plenum panel. Tighten the screw to 8 N.m (75 in. lbs.).
4. Reconnect the left headlamp and dash wire harness connector (7) to the wiper motor pigtail wire connector.
5. Reinstall the cowl plenum cover/grille panel (5) over the cowl plenum.
6. Reconnect the battery negative cable.
7. Close and latch the hood.
8. Reinstall both wiper arms (4) onto the wiper pivots.
