RAM 1500 Truck 2WD V8-5.7L VIN D (2003)
Control Module: Description and Operation
Fig.10 PCM/TCM Location
TRANSMISSION CONTROL MODULE
The Transmission Control Module (TCM) may be sub-module within the Powertrain Control Module (PCM) or a standalone module, depending on
the vehicle engine. The PCM, and TCM when equipped, is located at the right rear of the engine compartment, near the right inner fender.
The Transmission Control Module (TCM) controls all electronic operations of the transmission. The TCM receives information regarding vehicle
operation from both direct and indirect inputs, and selects the operational mode of the transmission. Direct inputs are hardwired to, and used
specifically by the TCM. Indirect inputs are shared with the TCM via the vehicle communication bus.
Some examples of direct inputs to the TCM are:
-
Battery (B+) voltage
-
Ignition "ON" voltage
-
Transmission Control Relay (Switched B+)
-
Throttle Position Sensor
-
Crankshaft Position Sensor
-
Transmission Range Sensor
-
Pressure Switches
-
Transmission Temperature Sensor
-
Input Shaft Speed Sensor
-
Output Shaft Speed Sensor
-
Line Pressure Sensor
Some examples of indirect inputs to the TCM are:
-
Engine/Body Identification
-
Manifold Pressure
-
Target Idle
-
Torque Reduction Confirmation
-
Engine Coolant Temperature
-
Ambient/Battery Temperature
-
DRBIII Scan Tool Communication
Based on the information received from these various inputs, the TCM determines the appropriate shift schedule and shift points, depending on the
present operating conditions and driver demand. This is possible through the control of various direct and indirect outputs.
Some examples of TCM direct outputs are:
-
Transmission Control Relay
-
Solenoids
-
Torque Reduction Request
Some examples of TCM indirect outputs are:
-
Transmission Temperature (to PCM)
-
PRNDL Position (to BCM)