RAM 1500 Truck 2WD V8-5.7L VIN D (2003)
Pilot Bearing: Service and Repair
REMOVAL
1. Remove transmission.
2. Remove clutch disc.
3. Use a suitable blind hole puller to remove pilot bearing.
INSTALLATION
1. Clean bearing bore with solvent and wipe dry with shop towel.
2. Install new bearing with clutch alignment tool (Fig. 19). Drive bearing into place with the letter side of the bearing facing the transmission.
Bearing should be flush with edge of bearing bore.
CAUTION: Do not allow bearing to become cocked and do not recess bearing.
3. Install clutch disc, pressure plate and transmission.
