RAM 1500 Truck 2WD V8-5.9L VIN Z LDC (1999)
Fig 5 Power Distribution Center Remove/Install
9. Remove the screw that secures the PDC to the left front fender wheel housing.
10. Remove the two screws that secure the PDC to the left front fender inner shield.
11. Remove the PDC and the headlamp and dash wire harness from the engine compartment as a unit.
NOTE: If the PDC is being replaced with a new unit, be certain to transfer each of the blade-type fuses, cartridge fuses and relays from the old PDC to
the proper cavities of the new PDC.
POWER DISTRIBUTION CENTER INSTALLATION
1. Position the PDC and the headlamp and dash wire harness unit in the engine compartment.
2. Install and tighten the two screws that secure the PDC to the left front fender inner shield. Tighten the screws to 8.4 Nm (75 in. lbs.).
3. Install and tighten the screw that secures the PDC to the left front fender wheel housing. Tighten the screw to 2.2 Nm (20 in. lbs.).
4. Install the eyelet of the battery positive cable take out onto the forward stud in the PDC.
5. Install and tighten the nut that secures the eyelet of the battery positive cable take out to the forward stud in the PDC. Tighten the nut to 8.4 Nm
(75 in. lbs.).
6. Install the eyelet of the battery negative cable take out onto the rearward stud in the PDC.
7. Install and tighten the nut that secures the eyelet of the battery negative cable take out to the rearward stud in the PDC. Tighten the nut to 5.6 Nm
(50 in. lbs.).
8. Reconnect the engine wire harness in-line connector to the PDC.
9. Install and tighten the screw that secures the engine wire harness in-line connector to the PDC. Tighten the screw until it clicks.
10. Install the cover onto the PDC.
11. Engage each of the retainers that secure the headlamp and dash wire harness to the vehicle body and chassis components.
12. Install all of the fasteners that secure each of the headlamp and dash wire harness ground eyelets to the vehicle body and chassis components.
13. Reconnect each of the headlamp and dash wire harness connectors.
14. Reconnect the battery negative cable.
